Gorilla Clear Grip Contact Adhesive #8040001, 3 oz - Pack of 3
- WATERPROOF – For indoor/outdoor use
- FAST GRAB – Holds in just seconds
- PERMANENT BOND
- CRYSTAL CLEAR
- HEAVY DUTY
- NO-RUN FORMULA
- PHOTO SAFE
- WASHER & DRYER SAFE
- BONDS: Metal, Glass, Fabric, Wood, Ceramic, Leather, Paper, Plastic*, and More!
*Not recommended for use on polystyrene, polypropylene or polyethylene products. Not for use on food contact surfaces. Do not dry clean. May cause damage to finished surfaces.
All surfaces should be clean and free of dirt, grease and oil. Best if used between 50°F and 90°F. Clear Grip® should only be used in a well ventilated area.
Apply adhesive to each surface to be bonded.
To maximize bond strength: Wait approximately two minutes for adhesive to partially dry before joining surfaces.
Press surfaces firmly together.
NOTE: Bond forms immediately and can be difficult to reposition.
Allow for a minimum of 24 hours for full cure. Cure time may increase with lower temperatures and when used on non-porous surfaces.
After each use, wipe nozzle with a dry cloth and tightly replace cap. Store in a cool, dry location. Tip: For easier re-opening, apply a thin coat of petroleum jelly to the threads before replacing cap. Store away from children and animals.
Wipe uncured adhesive with a dry cloth and clean with acetone, isopropyl alcohol, or citrus based solvents according to manufacturer’s instructions. Cured adhesive may be removed by scraping from surface.
When fully cured.
*NOTE: Not recommended for use on polystyrene, polypropylene or polyethylene products. Not for use on food contact surfaces. Do not dry clean. May cause damage to finished surfaces.
APPLICATION TEMPERATURE – 50° to 90° F, best at room temperature
OUTDOOR – Yes
MOISTURE RESISTANT – Waterproof
PAINTABLE – Yes – Can be painted with water and oil based paints, spray paint
SANDABLE – Yes
STAINABLE – Yes
CURED COLOR – Clear
STORAGE TIPS – Flammable adhesive, do not use or store near heat, sparks, flames, or while smoking. Store in a cool, dry location. Wipe nozzle clean before replacing cap, for easy re-open apply a thin coat of petroleum jelly to threads.
GAP FILLING – No
PHOTO SAFE – Yes
WASHER & DRYER SAFE – Yes